Error “7000-10-7F22” occurs when the ECU returns Conditions Not Correct (NRC 0x22) in response to an Open Communication request. Common causes include an incorrect IG status (engine running), selection of the wrong upgrade mode, and interference from aftermarket devices. This issue can be resolved by adjusting the vehicle to IG On, verifying the upgrade mode, and removing aftermarket devices.
Symptom
Error “7000-10-7F22” occurs immediately after the upgrade is initiated or during the initial stage, preventing the upgrade process from starting.
Cause
- The engine is running, preventing the communication conditions from being met (IG On is required)
- Incorrect upgrade mode selection (Auto/Manual)
- An aftermarket device is interfering with communication initialization
- Unstable voltage is preventing the ECU from remaining ready for communication
Resolution
Step 1) Adjust the IG status
Switch the vehicle from engine OFF to IG On.
(Most ECUs do not allow Open Communication while the engine is running.)
Step 2) Verify the upgrade mode
Confirm that the correct ECU/category is selected in Auto Mode or Manual Mode.
Step 3) Remove aftermarket devices
Remove all dash cams, communication modules, taxi equipment, and other devices that may interfere with communication, and then retry the upgrade.
Step 4) Stabilize the vehicle voltage
If the battery voltage is low, connect an external power supply or battery support unit.
Step 5) Perform a vehicle power reset
Caution: Disconnecting the negative (-) battery terminal may reset some vehicle settings.
1) Turn the vehicle power completely OFF.
2) Disconnect the negative (-) battery terminal for at least 5 minutes.
3) Reconnect the terminal, and then retry the upgrade.
Customer Support Center
For further assistance, contact the Customer Support Center and provide the VIN and event number.
Customer Support Center: 1588-3665 (Weekdays, 09:00–18:00)
Comments
0 comments
Please sign in to leave a comment.