If you receive an event file from KMC or HMC, you must first copy it to an SD card for use with the CVCI.
Follow the instructions below.
1. Delete all data from the SD card.
Format the SD card so that it is empty.
When formatting the SD card, select FAT/32KB.
2. Insert the SD card into the CVCI.
3. Pair the CVCI and trigger module (optional).
Follow the instructions at this URL (https://support-kia.gitauto.com/hc/en-gb/articles/360000727807).
* If you are unsure whether the CVCI and trigger module are paired correctly, perform the pairing procedure. Otherwise, proceed to step 4.
As a precaution, pair the CVCI and trigger module again.
* If the CVCI and trigger module fail to pair, repeat the pairing procedure several times.
If the issue persists, the CVCI or trigger module may have a hardware problem.
Contact us if either device requires repair.
4. Copy the event file to the SD card.
Copy the event file received from KMC or HMC to the SD card, and then insert the SD card into the CVCI.
5. Connect the CVCI to the vehicle's OBD-II connector.
6. Connect the trigger module to the vehicle's cigarette lighter socket.
7. When the "Enter" button on the trigger module illuminates green, the system is ready for a test drive.
* If the "Enter" button on the trigger module does not illuminate green at this step, there is a problem with the event file, not with the CVCI or trigger module.
Contact KMC or HMC—the sender of the event file—or the distributor hotline listed in GSW, and provide the vehicle's ROM ID.
Ask them to confirm whether the ROM ID is compatible with the event file.
Comments
0 comments
Please sign in to leave a comment.