Symptom: ECU upgrade in progress, error code [1000-C8-0001] occurs
Cause: Socket connection failure with gateway (non-CCU type) to perform Ethernet event
Resolution:
1. It is necessary to check whether the aftermarket equipment is installed on the car.
2. It is necessary to connect the ECI cable normally and check the tablet's fixed IP.
3. It is necessary to connect the diagnostic device and check the normal display of the sensor output of the gateway controller.
4. After removing the vehicle power connector, proceed with the installation work 5 minutes later and retry the ECU upgrade.
In case the above workaround doesn't resolve the issue, please contact your distributor or GIT assistance at following email for further support.
Call_center@gitamerica.com
: U.S.A and Canada
ics@gitauto.com
: Asia, Pacific, Middle East, Africa, Europe, Oceania, Central America, South America, Territory of U.S.A(Guam, Commonwealth of Puerto Rico, Saipan, and East Samoa)
Comments
0 comments
Please sign in to leave a comment.