Error Code 5100-04-0002: Failed to Change VCI Mode
- Verify that the target control unit is properly installed in the vehicle. (The control unit may not be installed depending on the vehicle trim level.)
- To change the operating mode of the Vehicle Communication Interface (VCI, VCI2, VCI3), perform a vehicle DTC scan once before starting the ECU upgrade.
- Because the Vehicle Communication Interface (VCI, VCI2, VCI3) can switch from diagnostic mode to ECU upgrade mode, performing a DTC scan places the Vehicle Communication Interface (VCI, VCI2, VCI3) in diagnostic mode and prepares it for the ECU upgrade.
- Test with a spare Vehicle Communication Interface (VCI, VCI2, VCI3) to determine whether the issue is with the Vehicle Communication Interface or the vehicle.
- If this error code occurs during recovery after an SW update failure, contact the Vehicle Quality Department or the control unit manufacturer.
Error Code 5021-27-7F24: Security Access Request Failed (Negative Response 24)
- This error occurs when Negative Response 24 (Request Sequence Error) is received from the control unit.
- Check the Vehicle Communication Interface (VCI, VCI2, VCI3) currently in use for any abnormalities.
- Perform an upgrade test using a spare Vehicle Communication Interface (VCI, VCI2, VCI3).
- Also test both wired and wireless (Bluetooth, Wi-Fi Direct) connections between the VCI and tablet PC.
- If the upgrade still cannot be completed after performing these tests, submit an inquiry with the Vehicle Identification Number (VIN).
- Inquiries are processed in the order received. Please wait for a response from a service engineer.
Comments
0 comments
Please sign in to leave a comment.