* G80(RG3) BDC-TPMS Sensor Data Unit Display Issue

1) Symptom

  - In the BDC-TPMS sensor data, pressure values are displayed for [Front/Left]/[Front/Right]/[Rear/Left]/[Rear/Right] but the unit is not displayed.
  - Normally, a unit option is available when accessing a sensor data item, allowing the unit to be changed. However, on this vehicle model, the unit option itself is not displayed, so the unit cannot be changed.

Explanation:

1. The Tire Pressure Unit item displays psi

   - This value indicates the pressure unit calculated by the TPMS; it is not an item configured in the diagnostic tool.

2. Unable to change the pressure units for Front Left/Front Right/Rear Left/Rear Right

   - TPMS sensor data is divided into the General Data group and the Event Data group.
In the attached screen, the group is expanded; therefore, the unit is not displayed and cannot be changed. (The cropped section on the left is the group selection screen.)
Collapse the group before proceeding. The unit can then be changed under the Unit option.

It has been confirmed that there is no issue with the diagnostic tool.