If you receive an event file from KMC, you must first copy it to the SD card used with the CVCI.
Please follow the instructions below.
1. Delete all data from the SD card.
Format the SD card so that it is empty.
When formatting the SD card, set the file system and allocation unit size to FAT / 32KB.
2. Insert the SD card into the CVCI.
3. Pair the CVCI with the trigger module (Optional).
* If you are unsure whether the CVCI and trigger module are paired properly, perform the pairing procedure. Otherwise, proceed to Step 4.
* If pairing fails, repeat the pairing procedure several times. If the issue persists, there may be a hardware fault in the CVCI or trigger module. Please contact your distributor (NSC) if repair is needed.
4. Copy the event file to the SD card.
Copy the event file received from KMC to the formatted SD card, and then insert the SD card into the CVCI.
5. Connect the CVCI to the vehicle's OBD-II connector.
6. Connect the trigger module to the vehicle's cigar lighter socket.
7. When the “Enter” button on the trigger module illuminates green, the system is ready for a test drive.
* If the “Enter” button on the trigger module does not illuminate green at this step, there is an issue with the event file (not with the CVCI or trigger module).
Please contact KMC (the representative who provided the event file) or your distributor hotline with the vehicle's ROM ID, and ask them to verify whether the ROM ID is compatible with the event file.
Comments
0 comments
Please sign in to leave a comment.